Cleaning And Looking After Your Steam Cleaners

Cleaning And Looking After Your Steam Cleaners

Steam cleaners are a revolutionary method of keeping a home sparkling clean, however, the units themselves need some tender loving care every now and again. In this article, we have covered some of the basics for keeping your steam cleaner in tip-top shape.

Cleaning-Your-Steam-MopCleaning Your Steam Mop

It’s important to look after your steam mop in order to make sure that you get the best results out of it. After every use, you should wipe across the entire exterior surface in order to remove any moisture and dirt. However, there are two other important parts to your steam mop that need to be kept clean and in good working order, the cleaning pads and the reservoir.

Cleaning Pads

Getting the cleaning pads clean is actually a really simple task. On most models, these pads will be removable. All you should need to do is remove the pad and put in the washing machine on your normal wash cycle, using your regular detergent. The only important tip to remember here is to ensure that the entire mop and the pads are completely cool before you remove them from the mop.

Sometimes you might find that the pads aren’t quite dirty enough to warrant a full machine clean, and this is fine. Instead of putting the pads in the machine, simply rinse them off in the sink. You can use a small amount of washing up liquid if you feel it’s necessary. Once the pads are clean, leave them to dry completely before you put them back on the mop.

Reservoir

You should be able to easily remove the steam mop tank from the rest of the unit. The point of cleaning this part of the steam mop is to eradicate any moisture that could develop into a harmful mold. To do this, simply take a clean and dry cloth and wipe around both the inside and outside of the reservoir until the whole thing is completely dry. If you find that your cloth gets dirty halfway through just swap it for a new one. Once the reservoir is clean you can pop it back on the unit.

Cleaning Your Steam Cleaner

Much like a steam mop, some general high-quality steam cleaners also come with detachable cloths or towels. These should be removed and washed thoroughly, either by hand or in the washing machine.

However, just keeping the cloths clean does not constitute adequately looking after your steam cleaner. You also need to ensure that you get rid of any limescale build-up within the machine.

You can make your own limescale remover using a solution of 1-part baking soda to 4 parts water. Fill the water tank with the homemade solution and turn it on so the solution heats up. Keep the unit warm for around one hour and then use the cleaner for a few minutes to allow the solution to run fully through the unit. Once you’ve done this, let the cleaner cool for at least 3 hours. Empty the reservoir of any remaining solution and flush through with fresh clean water.

Cleaning Your Carpet Steam Cleaner

Most of the time, carpet manufacturers will recommend using a hot water extraction method instead of steam cleaning in order to clean carpets. This is because sometimes the high level of moisture generated by the steam can damage the structural integrity of the carpet. However, steam cleaning can be useful when it comes to synthetic carpets and also for removing really stubborn stains. If you have been regularly using your steam cleaner to get rid of stubborn stains on your carpet, you may find that there’s quite a build-up of dirt and residue within your steam cleaner unit.

Like any general steam cleaner moisture is always the enemy so regular cleaning is a must. You should begin by removing any parts of the cleaner that can be removed e.g. the brush and the tank. These are fairly simple to clean and will likely only require a short soaking in some hot soapy water. You will then need to get into the inside of the unit and for this, you need to use the limescale remover recipe above.

Once all of the parts are clean carefully put everything backtoegther and continue with your cleaning regime.

Click Here to Leave a Comment Below 0 comments

Leave a Reply: